中文版 英文版
line
Engine coolant
position:Home> Engine coolant >
ENGINE COOLANT
source: admin??Time2019-11-10

 





 



project
The technical requirements

The experimental method
LEC- Ⅱ-15 HEC- Ⅱ-15 LELEC- Ⅱ-20 HEC- Ⅱ-20 LEC- Ⅱ-25 HEC- Ⅱ-25 LEC- Ⅱ-30 HEC- Ⅱ-30 LLEC- Ⅱ-35 HEC- Ⅱ-35 LEC- Ⅱ-40 HEC- Ⅱ-40 LEC- Ⅱ-45 HEC- Ⅱ-45 LEC- Ⅱ-50 HEC- Ⅱ-50
Density (20.0℃) /(/cm3) is not less than 1.036 1.044 1.050 1.055 1.060 1.065 1.070 1.076 SH/T0086
Freezing point /℃ is not higher than -15.0 -20.0 -25.0 -30.0 -35.0 -40.0 -45.0 -50.0 SH/T0090
Boiling point /℃ is not lower than 105.5 106.0 106.5 107.0 107.5 108.0 108.5 109.0 SH/T0089
Ash content /% (mass fraction) is not greater than 2.5 3.0 SH/T0067
PH 7.5~11.0 SH/T0069
Chlorine content /(ug/g) is not greater than 60 SH/T0621
The influence of organic coatings on automobiles No effect SH/T0084

 

It is made of high-quality ethylene glycol raw materials, distilled water and imported organic compound additives.
With anti-boiling, antifreeze, anti-corrosion, anti-cavitation erosion, anti-foam, rust, anti-scaling seven functions.
Good compatibility of rubber materials and seals does not corrode the polymer materials such as rubber tubes, wire insulation, etc. in the vehicle, and it will not cause the expansion and leakage of the contact parts of the hose.
The viscosity is suitable, the density is moderate, the fluidity is good, and the engine cooling effect is good.
 
Packing specification:16kg 4kgX6
 

 

返回列表
  • 上一篇:没有了
  • 下一篇:没有了
line

HARBIN YEW OIL CO., LTD. All rights reserved

Tel: 4000-666-447 Fax: Email: yew_oil@163.com

ICP:

返回顶部